One (1) Used Versa Model V300 S-84-120

Drape form and leading edge skin stretch press

Specifications:

Die table tonnage: 300 tons at 3000 psi

Die table type: Single cylinder with two (2) guiding rods

Die table length: 84"

Die table stroke: 24" vertical

Die table tilt: +/- 10degrees

Die table rotation: 90 degrees for longitudinal die forming

Total Jaw Length: 84"

Jaws: Pneumatic type, segmented (7 x 12") with integral bullnose, individually positioned

Jaw Swing: 0 to 45 degrees, individually adjustable

Jaw Slide: Hydraulic cylinders (2 - per side), jaw oscillation +/- 7.5 degrees

Jaw Carriage: Screw drive, each side by 5 HP motor

Minimum distance: For leading edge work, jaws over die table (available die stroke: 4")

Maximum distance between jaws: 120"

Control System:

DeMott Technologies design in roller type console with pressure gauge. Indicator lights. Pushbutton type for press functions: Control power on/off, pumping system on/off Right slide in/out/stop. Left slide in/out/stop. Right & left jaw open/close.Right & left carriage inboard/outboard, Die table up/down. Die table slow up. Die table tilt up/down., Die table position indicator mounted longitudinally on press beam.

Hydraulic System:

Free standing alongside press with 75 HP/550volt/3phase/60Hz motor - 75 amps

Pump : Denison 5000 psi capacity

Capacities: 200 gallon reservoir with heat exchanger

Floor space requirements: 19' x 14'

Pit dimensions: 96" wide x 80" long x 48" deep

Operator and maintenance manuals, foundation, sub-assembly drawings plus miscellaneous spare repair parts.